Foam carbon cleaner RESURS cleans the engine better due to 5 cycles of wetting, softening, dissolution, and washing off carbon deposits.

MAIN ADVANTAGES

• There is enough foam to clean 2 four-cylinder engines or 1 six-cylinder. This indicator is 4 times superior to analogs.
• Easy application thanks to a long tube (60 cm). The sprayer at the end of the tube ensures uniform foam filling of the entire upper part of the combustion chamber.
• RESURS does not cause corrosion of steel, aluminum, cast iron, and their alloys. Subject to the instructions, it does not affect the rubber and plastic elements of the internal combustion engine.
• Foam has a neutral odor. It does not contain acids, caustic alkalis, and ammonia, which, when heated, emit a deadly smell and vapor.

APPLICATION:

To clean the combustion chamber

1. Warm up the engine to operating temperature (40-50 ° С). Remove the coils and spark plugs. Set the pistons in the middle position.
2. Spray the product in the spark plug hole until it is completely filled with foam.
3. After the foam settles, let it react with the charcoal deposits for 5-7 minutes. Repeat steps 2 and 3. It’s recommended to repeat the application 5 times.
4. Pump out the remaining of the product with a tube or syringe, blow with compressed air.
5. Cover all spark plug holes with rags to prevent splashing of the liquid.
6. Turn on the starter for about 10 seconds.
7. Install all spark plugs and ignition coils.
8. Start the engine and let it idle for about 5 minutes. Thick smoke may escape from the exhaust pipe. It is necessary to increase the engine speed several times to 3000-4000 rpm until the smoke becomes less saturated.
9. It is recommended to repeat the process after 10 thousand km if the engine is heavily contaminated
10. It is advisable to change the filter and oil. To protect and restore the engine against wear, we recommend applying the RESURS Engine Restorer

To clean the inlet manifold

1. Heat the engine to operating temperature (40-50 ° С). Disconnect the plastic part of the inlet manifold. The valves should be closed.
2. Spray the product in the intake manifold until it is completely filled with foam.
3. After the foam settles, let it react with the charcoal for about 5-7 minutes. Repeat steps 3-4 about 5 times.
4. Repeat the application about 4-5 times.
5. Remove the remains of the product with a rag, then blow the manifold with compressed air, covering the spark plug holes with rags. Avoid contact with skin, eyes, mucous membranes.
6. Mount the intake manifold, then it is recommended to clean the combustion chamber