6 ''Coupling Collapsible pipe fitting mould

1. When the flaring pipe mold is energized, it is forbidden for the operator to test or measure the voltage of the DC motor control board and the voltage between the input point of the PROGRAMMABLE logic controller and the ground wire.

2. After using the expander of the flaring pipe mold for a period of time, it is necessary to regularly check whether the connecting parts of the machine are loose, and tighten them if necessary.

3. When using the flaring pipe fitting mold, it is strictly forbidden to move or remove the upper and lower limit blocks of the expander if the height of the automatic expander does not change. If you need a replacement, contact the manufacturer or read the instructions.

4. The turntable of flaring pipe mold should rotate clockwise, not reverse.

5. It is strictly prohibited to stand under the die frame of the automatic puffing machine, that is, under the parts of the membrane system, to pile up any sundries.

6. When the expansion frame starts to work, do not stretch the film into other objects to avoid damaging parts and fingers.

7. Once the power of the expander is grounded, if you need technical problems, you must contact the manufacturer to find a professional. Operators must regularly check electrical and electrical connections, connect and clean electrical cabinets.