Get Quick Quote From Supplier
Dear Sir/Madam,I would like to order 10,000 pieces per month of aluminum housing for housing the LED Street Lamp (100 W) module and photo sensor attached on top of it pointing the sky. FROM YOU, I DO NOT NEED ANYTHING INSIDE: LED CIRCUIT OR LED LAMP OR DRIVER ASSEMBLY AS WE MANUFACTURE THESE COMPONENTS HERE IN USA.Delivery Address:Sandy KumarSOLATRON INC.100 Westover LaneSchaumburg, ILLINOIS 60193 (NEAR CHICAGO)USA Phone: 1-847-895-1848What is the (A) total pricing including shipment by Sea/Road? (B) Delivery Time?SPECIFICATIONS OF ALUMINUM CASING:1. Your housing should have a PHOTO SENSOR with the housing to turn on the power when it is dark and turn off the power when it is day light. The sensor should have a setting knob to adjust the day light brightness set point to let the sensor trigger on or off the driver„¢s switch. 2. High-purity Aluminum reflector on the inner side of the casing3. DIE CAST Aluminum alloy Housing with fins on top to cool down the device.4. Top side must be FLAT so that the LED PCB can be glued to it.5. Dimension: Length: 20 Inch, Width: 10 Inch, Height: 4 Inch6. ALL outside of the housing will be super durable thermoset powder coated on the outside for weather resistance. Coating thickness should be about 3 mm thickness. Coating can be black, white or grey. 7. Durable Tempered Glass on the bottom side (20x10). The glass should seal well using good quality silicone gasket and a clamp or screws.8. On one side of the 10x4 wall there should be a hole between 2.75 inch and 3.00 inch diameter. This hole will be used to insert the power wiring from the street pole to the LED lamp.9. The remaining three sides of the 10x4 walls will be just flat.10. The top side (20x10) should have a photo sensor tightly attached to the top with weather proof sealing. The sensor will have three wires: live, neutral and ground to connect with the driver placed inside the housing.