12v Infrared Sensor Motion Detector, Security Motion Sensors Bs019

12v infrared sensor motion detector, security motion sensors BS019

 Description:

The PIR Sensor Switch detects PIR body heat and automatically switches the light ON and turning it OFF again after a time adjustable from 6 seconds to 12 minutes. PIR sensor switch Combined intelligent control and energy saving, it wildly used in aisles, basements, restrooms, etc. Help to saving 20%~80% of your energy.

Performance Characteristics:

1. Supplied by 12VDC power, easy for install and using, internal without batteries.

2. High sensitivity, stable work, strong anti-interference capability.

3. Reliable quality, switch life more than 20 million times.

Specification:

1. Operating voltage:12VDC

2. Power consumption:<0.02W

3. Load power:12V 60W

4. Brightness sensitivity: 10Lux±20%, 10Lux~200Lux±20% (optional)

5. Delay time: 30s±20%, 5s~300s±30% (optional)

6. Induction distance:5~8m.

7. Induction angle: about 115 °

8. Diameter: φ95mm*35mm

Installation Circuit:

Note:

1. Installation strictly follow product wiring diagram, do not short circuit.

2. Recommend one switch control one load, when the load is too large or to small, please consult to manufacturers.

3.Keep distance between switch and load more than 0.3 meter, do not exposed to direct sun light or lighting ,don’t put it in rapid environmental changes(eg: big wind).

4. Don’t conduct the hot line job, please electrify only after sensor switch has been installed

5. The switches have starting time after connecting the electricity. About 1-2 minutes later it will work normally. If normally using, switches will always connect the electricity, so no need worry about this.

6. The infrared switches are based on detect the difference between the human body temperature and the environment temperature .The sensitivity will be affected by many factors such as the environment temperature, the walk speed and direction.( the induction distance is about 3~5 meters as the environment temperate higher in summer, and about 5~7M in winter as the environment temperate lower in winter, that is normal).

7. The switches use the unit doublet probes, so the sensitivity in right-left direction is a little difference from up-down direction, which is normal.

8.    105  could adjust the brightness of the PIR sensor switch, clockwise will increase the brightness value, counter-clockwise will decrease the brightness value. The brightness value higher, means the PIR sensor switch will work even at a very bright environment. The brightness value lower PIR sensor switch will only work at a darker environment.  204  could adjust the delay time, clockwise will increase the delay time, while counter-clockwise will decrease.

Factory profile